GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2007 🢒 Aveo HB 🢒 Engine 🢒 Engine Controls and Fuel - 1.6L (L91) 🢒 Evaporative Emission Canister Vent Solenoid Valve Replacement

Removal Procedure

    Object Number: 1528391 Size: SH

    Caution: Do not allow smoking or the use of open flames in the area where work on the fuel or EVAP system is taking place. Anytime work is being done on the fuel system, disconnect the negative battery cable, except for those tests where battery voltage is required.

  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the evaporative emission (EVAP) canister vent solenoid valve bracket bolt.

    3. Object Number: 1528395 Size: SH
  3. Remove the EVAP canister vent solenoid valve bracket.

    4. Object Number: 1528398 Size: SH
  4. Disconnect the EVAP canister vent solenoid valve electrical connector.
  5. Remove the EVAP canister vent solenoid valve hose clip.
  6. Disconnect the EVAP canister vent solenoid valve hoses.
  7. Remove the EVAP canister vent solenoid valve.

Installation Procedure

    Object Number: 1528398 Size: SH
  1. Connect the EVAP canister vent solenoid valve hoses.
  2. Install the EVAP canister vent solenoid valve hose clip.
  3. Connect the EVAP canister vent solenoid valve electrical connector.

    4. Object Number: 1528395 Size: SH
  4. Install the EVAP canister vent solenoid valve bracket to the EVAP canister vent solenoid valve.

    5. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1528391 Size: SH
  5. Install the bolt to the EVAP canister vent solenoid valve bracket.

    6. Tighten
    Tighten the EVAP canister vent solenoid valve bracket bolt to 4 N·m (35 lb in).

  6. Lower the vehicle.
  7. Connect the negative battery cable, if disconnected.