Clutch Rotor and Bearing Removal V5 Compressor

Tools Required

Caution: Refer to Battery Disconnect Caution in the Preface section.




1. Disconnect the negative battery cable.
2. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging .
3. Remove the compressor. Refer to Air Conditioning Compressor Replacement .
4. Remove the clutch drive plate and hub assembly. Refer to Compressor Clutch Plate and Hub Assembly Removal .



5. Remove the pulley rotor and the bearing assembly retaining ring using the J 6083 .
6. Install the J 33020  (1) into the inner circle of slots in the pulley rotor. Turn the J 33020  (1) clockwise in the slots to engage the puller tangs with the segments between the slots in the rotor.
7. Hold the J 33020  (1) in place and tighten the puller bolt against the compressor shaft to remove the pulley rotor and the bearing assembly.




Notice: The rotor hub must be properly supported to prevent damage to the pulley rotor during bearing removal.

8. Remove the puller bolt from the J 33020 . With the puller tangs still engaged in the rotor slots, invert the assembly onto a solid flat surface or blocks.
9. Drive the bearing out of the rotor hub with the J 9398-A  (2) and the J 8092  (1).

Clutch Rotor and Bearing Removal SP10 Compressor

Tools Required

J 9553-01 O-Ring Remover

1. Remove the clutch and drive assembly. Refer to Compressor Clutch Plate and Hub Assembly Removal .
2. Remove the shims using the J 9553-01 O-ring remover.



3. Remove the pulley ring retainer using the snap ring pliers (1).
4. Pull the pulley groove with both hands until the pulley and bearing assembly is free.