GM Service Manual Online
For 1990-2009 cars only
Table 1: Radio Scan Tool Data Parameters
Table 2: Radio Scan Tool Output Controls

Radio Scan Tool Data Parameters

Parameter

Expected Value

Definition

Operating Conditions: Ignition ON

Antenna Module

Enabled

This scan tool displays Enabled or Disabled. This is the state of the antenna module.

Auxiliary Audio Input

Present

The scan tool displays Present or Not Present. This is the state of the auxiliary audio input.

DRR

Present

The scan tool displays Present or Not Present. This is the state of the DRR.

Ign. Cycles Since last DTC

Varies

The scan tool displays the number of ignition cycles since the last DTC.

Phone Signal

Present

The scan tool displays Present or Not Present. This is the state of the phone signal.

Power Mode

Run

The scan tool displays Off, Accessory, Run or Crank Request. This is the state of the ignition switch.

Power Mode Config.

Normal Mode

The scan tool displays Bench Mode or Normal Mode. This is the configuration of the power mode.

Signal Strength

Varies

This displays dBuV. This is the signal strength of the radio.

Theft Armed

Learned VIN

The scan tool displays Learned VIN or No VIN. This is the state of the VIN programming in the radio.

Theft Lock Status

Inactive

The scan tool displays Active or Inactive. This is the state of the theft lock system.

Video Display

Varies

The scan tool displays Present or Not Present. This is the state of the video display.


Radio Scan Tool Output Controls

Scan Tool Output Control

Description

Left Front Speaker

Commanding the speaker ON will turn OFF all speakers except this speaker.

Commanding the speaker OFF will turn OFF all speakers.

Left Rear Speaker

Commanding the speaker ON will turn OFF all speakers except this speaker.

Commanding the speaker OFF will turn OFF all speakers.

Right Front Speaker

Commanding the speaker ON will turn OFF all speakers except this speaker.

Commanding the speaker OFF will turn OFF all speakers.

Right Rear Speaker

Commanding the speaker ON will turn OFF all speakers except this speaker.

Commanding the speaker OFF will turn OFF all speakers.