GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2008 🢒 Avalanche - 4WD 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Brake Master Cylinder Primary Piston Position Sensor Replacement

Removal Procedure
  1. Place the ignition switch in the OFF position.
  2. Disconnect the primary piston position sensor electrical connector.

    3. Object Number: 1892243 Size: SH
  3. Remove the 2 primary piston position sensor screws (1).
  4. Remove the primary piston position sensor (2).

    5. Tilt the rear of the position sensor downward and remove the sensor.

Installation Procedure

    Object Number: 1892243 Size: SH
  1. Install the primary piston position sensor (2).

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the 2 primary piston position sensor screws (1).

    3. Tighten
    Tighten the screws to 10 N·m (89 lb in).

  3. Connect the primary piston position sensor electrical connector.