Tools Required

Caution: When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury.

Caution: If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.

Important: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.

1. Open the liftgate.

Caution: If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.

2. Cover the following parts to protect from broken glass.

2.1.	The upper dash pad

2.2.	The defroster outlets and A/C outlets

2.3.	The seats and the carpeting

3. Remove the right or left side applique.




Important: Keep the cutting edge of the tool against the quarter window from inside the vehicle. This will allow the urethane adhesive to be separated from the window.

4. Use J 24402-A , J 39032 , or equivalent in order to remove the quarter window.

•	Leave a base of urethane on the pinchweld flange.

•	The only suitable lubrication is clear water.

5. If the original reveal molding on the window is damaged, replace the molding.



6. With the aid of an assistant, use the suction cups to remove the window from the opening.

1. Install the quarter window into the opening. Refer to Adhesive Installation of Stationary Windows .
2. Install the right of left side applique.
3. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
4. Close the liftgate window.