For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC C0558 00: Calibration Data Not ProgrammedCircuit/System Description
The electronic suspension control module (ESCM) performs checks of internal calibration data. If a fault condition is detected, the ESCM will set the fault DTC, and may, depending upon the fault type, turn ON the SERVICE SUSPENSION SYSTEM message. Recovery from any controller fault condition is attempted only after the ignition is cycled ON and OFF.
Conditions for Running the DTC
| • | Battery voltage is between 9-16 volts |
| • | Ignition is ON. |
Conditions for Setting the DTC
| • | The DTC is set when any calibration faults internal to the ESCM are detected. |
| • | The fault is detected during 3 consecutive ignition cycles, or during the same ignition cycle after clearing the DTC with the scan tool. |
Action Taken When the DTC Sets
| • | The ESCM disables all ALC functionality. |
| • | The ESCM sends a message to the instrument panel cluster (IPC) to display the SERVICE SUSPENSION SYSTEM message. |
Conditions for Clearing the DTC
| • | A current DTC will clear when the ESCM no longer senses the malfunction and the ignition is cycled ON and OFF. |
| • | The DTC will remain in history until 50 ignition cycles have occurred. |
Reference Information
Schematic Reference
Electronic Suspension Control Schematics
Connector End View Reference
Description and Operation
Electronic Suspension Control Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
Verify that DTC C0558 is not set.
| ⇒ | If the DTC is set, perform the Suspension Position Calibration procedure. If the DTC resets replace the ESCM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for ESCM replacement, setup, and programming
