GM Service Manual Online
For 1990-2009 cars only

Intermittent Low Battery Voltage, Engine Will Not Crank, Engine Cranks But Will Not Start, Charging System Light On, Service Battery Charging System Message Displayed, DTC B1516 Set (Reprogram BCM)

Subject:Intermittent Low Battery Voltage, Engine Will Not Crank, Engine Cranks But Will Not Start, Charging System Light On, Service Battery Charging System Message Displayed, DTC B1516 Set (Reprogram BCM)

Models:2007 Cadillac Escalade Models
2007 Chevrolet Avalanche, Silverado, Suburban, Tahoe
2007 GMC Sierra, Yukon Models
1500 and 2500 Series Vehicles Only



This bulletin is being revised to remove the Additional Diagnostic Tips section, update the Correction and Warranty Information. Please discard Corporate Bulletin Number 06-06-03-013B (Section 06 -- Engine/Propulsion System).


Do This

Don't Do This

Reprogram the BCM.

Do NOT replace the BCM or battery current sensor.

Condition

Some customers may comment of one or more of the following conditions:

    • Charging system light on.
    • Service battery charging system message displayed.
    • Intermittent low battery voltage.
    • Vehicle will not crank.
    • Vehicle cranks but will not start.
    • Diagnostic Trouble Code (DTC) B1516-Battery Current Sensor Performance Signal Invalid.

Cause

This condition may be caused by the Body Control Module (BCM) calibrations that create a lower battery state of charge than intended in low electrical power usage modes.

Correction

Important:  Verify that the 12-volt battery has a battery charge of 12 to 16 volts. The battery must be able to maintain a charge during programming. Only use approved Midtronics 165-PCS charger or equivalent to maintain proper battery voltage during programming. The J2534 MDI will reprogram the modules in less time than the Tech 2® scan tool.

A revised calibration has been developed to address these conditions. Technicians are to reprogram the BCM using the latest software available on TIS2WEB. Refer to the Body Control Module Programming and Setup procedure in SI.

Warranty Information

For vehicles repaired under warranty, use:

Labor Operation

Description

Labor Time

N4808

Body Control Module Reprogramming with SPS

Use Published Labor Operation Time