Important: When performing the following procedures, use only hand tools to remove and install the drain and fill plugs.

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
3. Remove the fill plug.



4. Remove the drain plug.

Notice: Refer to Fastener Notice in the Preface section.





Important: Use only drain and fill plugs that are made from aluminum. Steel or brass plugs are not compatible with the magnesium case.

1. Install the drain plug.

Tighten
Tighten the plug to 20 N·m (15 lb ft).

2. Fill the transfer case to the bottom of the fill plug hole with the recommended fluid. Refer to Approximate Fluid Capacities .



3. Install the fill plug.

Tighten
Tighten the plug to 20 N·m (15 lb ft).

4. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
5. Lower the vehicle.