Gap Between Front Fascia and Fender on Left or Right Side of Wheel Opening (Install Fastener)

Some customers may comment on a visible gap between the front fascia and fender or that the fascia is not flush to the fender.

The body (at fender to fascia interface) may be slightly wider than the fascia at the wheel opening.

Install a fastener through the top of the rear edge of the front fascia at the wheel opening on both left and right side of the vehicle.

DO NOT replace the front fascia.

1. On Avalanche 2500 vehicles only, remove the fender upper wheel well extension molding by loosening the fasteners.



2. Using a 3.2 mm (1/8 in) drill bit, drill a hole at the location identified in the illustration.
3. Coat the fastener threads with Teflon® lubricant ("Superlube"), P/N 12371287.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Notice: To avoid damage to corrosion protection, do not allow fastener threads to scrape across inside fender surface during tightening.

4. Install the fastener to the fascia.

Tighten
Tighten the fastener to 5 N·m (44 lb in).

5. On Avalanche 2500 vehicles, install the fender upper wheel well extension molding.

Tighten
Tighten the fasteners to 5 N·m (44 lb in).

6. Repeat Steps 1-5 on the opposite side.

For vehicles repaired under warranty, use: