GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2003 🢒 Avalanche - 2WD 🢒 Body and Accessories 🢒 Wiring Systems 🢒 Instrument Panel Electrical Center or Junction Block Replacement - Right Side

Removal Procedure
  1. Remove the right side end panel.
  2. Push in the tabs in order to remove the fuse block.

    3. Object Number: 375032 Size: SH
  3. Pull out the fuse block out of the instrument panel (I/P) in order to remove the retaining bolt.
  4. Loosen the bolt.
  5. Insert a screw driver between the wire harness block and fuse block in order to separate.
  6. Separate the fuse block from the I/P harness block.
  7. Remove the I/P wiring harness block from the vehicle.

Installation Procedure
  1. Install the fuse block to the I/P wire harness block.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the retaining bolt.

    3. Tighten
    Tighten the bolt to 6 N·m (53 lb in).


    Object Number: 375030 Size: SH
  3. Install the fuse block to the I/P until it clicks in place.

    4. Object Number: 375032 Size: SH
  4. Connect the wiring connectors to the fuse block.

    5. Refer to Electrical Center Identification Views to ensure the right connections are made.

  5. Install the right side end panel.