GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2005 🢒 Astro - 4WD 🢒 Brakes 🢒 Park Brake 🢒 Park Brake Cable Mounting Bracket Replacement

Removal Procedure

    Object Number: 930615 Size: SH
  1. Release the parking brake.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Disconnect the rear cables from the equalizer. Refer to Park Brake Cable Equalizer Replacement .
  4. Remove the rear cables from the mounting bracket by depressing the retaining tabs and pulling rearward.
  5. Remove the cable support bracket bolts.
  6. Remove the cable support bracket.

Installation Procedure

    Object Number: 930615 Size: SH
  1. Install the cable support bracket.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the cable support bracket bolts.

    3. Tighten
    Tighten the bolts to 24 N·m (18 lb ft).

  3. Install the rear cables to the mounting bracket by inserting the cable until all the retaining tabs snap into place.
  4. Connect the rear cables to the equalizer. Refer to Park Brake Cable Equalizer Replacement .
  5. Remove the safety stands and lower the vehicle.