Front Wheel Hub, Bearing, and Seal Replacement RWD

1. Raise the vehicle. Referto Lifting and Jacking the Vehicle in General Information.
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
3. Remove the brake rotor. Refer to Front Brake Rotor Replacement in Disc Brakes.
4. Remove the wheel hub and bearing mounting bolts.



5. Remove the wheel speed sensor mounting bolt from the wheel hub and bearing.
6. Disconnect the wheel speed sensor from the wheel hub and bearing.



7. Disengage wheel hub and bearing from steering knuckle.
8. Remove wheel speed sensor through the access hole in the splash shield.
9. Remove the wheel hub and bearing and splash shield.
10. Remove the splash shield from the wheel hub and bearing.

1. Install the splash shield to the wheel hub and bearing.
2. Install the wheel speed sensor through the access hole in the splash shield.
3. Install the wheel hub and bearing and splash shield to the steering knuckle.



4. Install the wheel speedsensor to the wheel hub and bearing.

Notice: Refer to Fastener Notice in the Preface section.

5. Install the wheel speed sensor mounting bolt to the wheel huband bearing.

Tighten
Tighten the wheel speed sensor mounting bolt to 18 N·m(13 lb ft).




6. Install the wheel hub and bearing mounting bolts.

Tighten
Tighten the wheel hub and bearing mounting bolts to 180 N·m(133 lb ft).

7. Install the brake rotor. Refer to Front Brake Rotor Replacement in Disc Brakes.
8. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
9. Lower the vehicle.

Front Wheel Hub, Bearing, and Seal Replacement AWD

Tools Required

J 45859 Axle Remover

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
3. Remove the brake rotor. Refer to Front Brake Rotor Replacement in Disc Brakes.
4. Remove the wheel drive shaft nut and the washer.



5. Disengage the wheel drive shaft from the wheel hub and bearing using J 45859 .



6. Remove the wheel hub and bearing mounting bolts.



7. Remove the wheel speed sensor mounting bolt from the wheel hub and bearing.
8. Disconnect the wheel speed sensor from the wheel hub and bearing.



9. Disengage wheel hub and splash shield from steering knuckle.
10. Remove wheel speed sensor through the access hole in the splash shield.
11. Remove the wheel hub and bearing and splash shield.
12. Remove the splash shield from wheel hub and bearing.

1. Install the splash shield to the wheel hub and bearing.
2. Install the wheel speed sensor through the access hole in the splash shield.
3. Install the wheel hub and bearing and splash shield to the steering knuckle.



4. Install the wheel speed sensor to the wheel hub and bearing.

Notice: Refer to Fastener Notice in the Preface section.

5. Install the wheel speed sensor mounting bolt to the wheel hub and bearing.

Tighten
Tighten the wheel speed sensor mounting bolt to 18 N·m (13 lb ft).




6. Install the wheel hub and bearing mounting bolts.

Tighten
Tighten the wheel hub and bearing mounting bolts to 180 N·m (133 lb ft).




7. Install the wheel drive shaft washer and the nut.

Tighten
Tighten the wheel drive shaft nut to 235 N·m (173 lb ft).

8. Install the brake rotor. Refer to Front Brake Rotor Replacement in Disc Brakes.
9. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
10. Lower the vehicle.