- Install the lock bolt spring (3) into the steering column housing assembly (5).
- Position the cutout in the lock bolt assembly (4) at the 6 o'clock position.
- Install the lock bolt assembly (4) into the steering column housing assembly (5).
- Push the lock bolt assembly (4) into the steering column housing assembly (5) until the lock bolt assembly is flush with the steering column housing assembly (5).
- Align the electronic lock module assembly (2) with the steering column housing assembly (5).
- Screw the 3 pan head tapping screws (1) into the electronic lock module assembly (2).
- Place steering column lock cylinder set into the OFF position.
- Place the shift lever into the PARK position.
- Press the locking tab on the end of the park lock cable assembly (1) into the slot in the electronic lock module assembly.
- Install the ignition and key alarm switch assembly only. Refer to Ignition and Key Alarm Switch Assembly - Assemble - Off Vehicle .
- Install the upper column components. Refer to Steering Column Jacket - Assemble - Off Vehicle .
Install the electronic lock module assembly (2) onto the steering column housing assembly (5).
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the 3 pan head tapping screws to 7N·m (62 lb in).
