GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1999 🢒 Alero Export 🢒 Engine 🢒 Engine Controls - 3.4L 🢒 Ignition Control Module Replacement

Removal Procedure

    Object Number: 162818 Size: SH
  1. Disconnect all electrical connectors at ignition control module.
  2. Note the position of spark plug wires for installation and disconnect the spark plug wires from ignition coils.
  3. Remove the screws securing coil assemblies to ignition control module.
  4. Remove the module/coil assembly from the ignition control module bracket.
  5. Disconnect the coils from ignition control module.

Installation Procedure

    Object Number: 162818 Size: SH
  1. Install the coils to the ignition control module (3).
  2. Position the module/coil assembly on the ignition control module bracket.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the screws.

    4. Tighten
    Tighten the screws to 4-5 N·m (40 lb in).

  4. Connect the spark plug wires as noted during the removal.
  5. Connect the electrical connectors to the ignition control module.