GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2009 🢒 XLR 🢒 Preface 🢒 Dangers, Warnings, and Cautions 🢒 Electronic Suspension Rear Position Sensor Replacement

Removal Procedure
  1. Turn OFF the ignition switch.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.

    4. Object Number: 925365 Size: SH
  4. Disconnect the electronic suspension control (ESC) position sensor harness connector.

    5. Object Number: 925362 Size: SH
  5. Disconnect the position sensor link from the control arm link stud.
  6. Remove the position sensor mounting bolt.
  7. Remove the position sensor from the vehicle.

Installation Procedure

    Object Number: 925362 Size: SH
  1. Install the position sensor to the vehicle.

    2. Caution: Refer to Fastener Caution in the Preface section.

  2. Install the position sensor mounting bolt and tighten to 7 N·m (62 lb in).
  3. Connect the position sensor link to the control arm link stud.

    4. Object Number: 925365 Size: SH
  4. Connect the ESC position harness connector.
  5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
  6. Lower the vehicle.