For 1990-2009 cars only
Removal Procedure
- Disconnect the negative battery cable.
- Remove the I/P carrier. Refer to Instrument Panel Carrier Replacement.
- Carefully lift the head-up display (HUD) electrical harness from between the instrument panel cluster (IPC) and the HUD.
- Disconnect the HUD electrical connector from the IPC.
- Remove the retaining screws that secure the IPC to the steering column bracket.
- Raise the rear of the IPC slightly to release the locator tab. Reposition the IPC to access the retaining screw that secures the HUD to the steering column bracket.
- Loosen the retaining screw that secures the HUD to the steering column bracket.
- Remove the HUD retaining nuts.
- Remove the HUD from the vehicle.
Warning: Refer to Battery Disconnect Warning in the Preface section.
Installation Procedure
- Transfer the retaining screw and nut to the replacement HUD.
- Install the HUD to the vehicle:
- Install the HUD retaining nuts and tighten to 5 N·m (44 lb in).
- Tighten the screw that retains the HUD to the steering column bracket to 3 N·m (27 lb in).
- Install the retaining screws that secure the IPC to the steering column bracket and tighten to 3 N·m (27 lb in).
- Connect the HUD electrical connector to the IPC.
- Carefully secure the HUD electrical harness (1) down between the IPC and the HUD as shown.
- Install the I/P carrier. Refer to Instrument Panel Carrier Replacement.
- Connect the negative battery cable. Tighten the cable bolt to 15 N·m (11 lb ft).
- Refer to Control Module References for programming and setup information.
| 2.1. | Install the HUD onto the dash panel mounting studs. |
| 2.2. | Slide the HUD retaining screw into the slot on the steering column bracket. |
Caution: Refer to Fastener Caution in the Preface section.
