For 1990-2009 cars only
Removal Procedure
Caution: Refer to Oxygen Sensor Caution in the Preface section.
Note:
• Remove oxygen sensors with the engine temperature above 48°C (120°F). Otherwise the oxygen sensors may be difficult to remove. • A special anti-seize compound is used on the oxygen sensor threads. New service sensors should already have the compound applied to the threads. Coat the threads of a reused sensor with anti-seize compound P/N 5613695 or equivalent.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
- Disconnect the forward oxygen sensor electrical connector.
- Remove the forward (1) oxygen sensor from the exhaust manifold.
Installation Procedure
- Install the heated oxygen sensor (HO2S) (1) in the exhaust manifold and tighten to 41 N·m (30 lb ft).
- Connect the oxygen sensor connector.
- Lower the vehicle.
Caution: Refer to Fastener Caution in the Preface section.
