GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Caution: Handle the electronic throttle control components carefully. Use cleanliness in order to prevent damage. Do not drop the electronic throttle control components. Do not roughly handle the electronic throttle control components. Do not immerse the electronic throttle control components in cleaning solvents of any type.

  1. Remove the left instrument panel (I/P) on the lower closeout insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side.

  2. Object Number: 1252542  Size: SH
  3. Disconnect the electrical connector (1) from the accelerator pedal sensor module.

  4. Object Number: 931700  Size: SH
  5. Remove the accelerator pedal mounting bolts (1).
  6. Remove the accelerator pedal (2).

Installation Procedure


    Object Number: 931700  Size: SH
  1. Install the accelerator pedal to the steering column support bracket.
  2. Caution: Refer to Fastener Caution in the Preface section.

    Note: Always use a torque wrench in order to obtain the proper torque.

  3. Install the accelerator pedal mounting bolts (1) and tighten to 10 N·m (89 lb in).

  4. Object Number: 1252542  Size: SH
  5. Connect the accelerator pedal sensor module electrical connector (1).
  6. Check for correct carpet fit under the accelerator pedal.
  7. Install the left I/P on the lower closeout insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side.