Tools Required

1. Remove the right secondary camshaft tensioner (2). Refer to Secondary Camshaft Drive Chain Tensioner Replacement - Right Side .
2. Remove the right camshaft position actuator housing. DO NOT remove the camshaft sensors from the housing. Refer to Camshaft Position Actuator Housing Replacement - Right Side .



3. Using the J 39946 (1) , rotate the crankshaft until both camshaft position actuator timing marks are near the top of their rotation.

Caution: Refer to Camshaft Holding Tool Caution in the Preface section.




4. Install the EN 46328 (2) .




Important: The secondary timing chain has black links that are used for alignment when the primary and secondary timing gear and chain assemblies are being installed together. IT IS NOT NECESSARY for the black chain links to be aligned with the camshaft actuator timing marks when the secondary chain and gear components are being serviced separately.

5. Use a paint stick to create a mark on the timing chain link (1) adjacent to each camshaft position actuator timing mark (2, 3).
6. Use a paint stick to create a mark on a primary chain link and intermediate primary chain sprocket tooth adjacent to the primary chain link.



7. Use an open end wrench on the hex cast into the right exhaust camshaft to prevent the camshaft from rotating when loosening the camshaft oil control valve.



8. Loosen and remove the right exhaust oil control valve.
9. Slide the right exhaust camshaft actuator off of the camshaft, disengage the sprocket teeth from the secondary timing chain, and remove the actuator.



10. Remove the right secondary camshaft drive timing chain shoe bolt.



11. Remove the right secondary camshaft drive timing shoe.
12. Clean and inspect the camshaft timing drive components. Refer to Camshaft Timing Drive Components Cleaning and Inspection .

1. Position the right secondary camshaft drive chain shoe in through the right front cylinder head as shown.

Notice: Refer to Fastener Notice in the Preface section.




2. Install the right secondary camshaft drive chain shoe bolt.

Tighten
Tighten the secondary camshaft drive chain shoe bolt to 25 N·m (18 lb ft).

3. Install the right secondary camshaft drive chain tensioner. Refer to Secondary Camshaft Drive Chain Tensioner Replacement - Right Side .
4. Install the right exhaust camshaft actuator. Refer to Camshaft Position Actuator Replacement - Bank 1 (Right Side) Exhaust .



5. Ensure that the previously created paint marks (1, 3) still line up with the sprocket timing marks (2, 4).