Tools Required

J 22610 Service Boot Clamp Installer

1. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .




Important: Take care when handling the mass air flow/intake air temperature (MAF/IAT) sensor. Do not dent, puncture, or otherwise damage the Honeycell located at the air inlet end of the MAF/IAT. Do not touch the sensing elements. Do not allow anything, including cleaning solvents and lubricants, to come in contact with the sensing elements. Use a small amount of a non-silicone based lubricant on the air duct only, to aid in the installation. Do not drop or roughly handle the MAF/IAT sensor.

2. Remove the air intake duct clamps from the MAF/IAT sensor and the throttle body.



3. Remove the MAF/IAT sensor.

Important: The embossed arrow on the MAF/IAT sensor indicate the proper air flow direction. The arrow must point toward the engine.

1. Install the MAF/IAT sensor into the air intake duct at the air cleaner housing.



2. Install the air intake duct to the MAF/IAT sensor and the throttle body.
3. Install the clamps.



4. Connect the electrical connector of the MAF/IAT .