GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2006 🢒 XLR 🢒 Body 🢒 Seats 🢒 Driver or Passenger Seat Replacement

Removal Procedure

    Object Number: 1294374 Size: SH
  1. Place a protective cover over the sill plate and door trim panel and lower the folding top to provide additional space for seat removal.
  2. Tilt the steering wheel full up, if required.
  3. Disable the SIR system. Refer to SIR Disabling and Enabling or to SIR Disabling and Enabling in SIR.

    4. Object Number: 1247931 Size: SH
  4. Position the seat rearward.
  5. Remove the push pins and covers from the front of the adjuster legs.
  6. Remove the nuts from the front of the adjuster legs.
  7. Position the seat forward.
  8. Remove the nuts attaching the rear adjuster legs.
  9. Disconnect the seat electrical connector.
  10. Remove the seatbelt retaining nut and the seatbelt from the anchor stud.
  11. Remove the seat.

Installation Procedure

    Object Number: 1247931 Size: SH
  1. Position the seat on the rear studs.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the seatbelt and the retaining nut to the seat stud.

    3. Tighten
    Tighten the nut to 41 N·m (31 lb ft).

  3. Lift the front of the seat and connect the electrical connector.
  4. Install the nut to the rear inboard stud .
  5. Install the nut to the rear outboard stud.

    6. Tighten
    Tighten the nuts to 50 N·m (37 lb ft).

  6. Move the seat rearward.
  7. Install the nuts to the front adjuster legs.

    8. Tighten
    Tighten the nuts to 50 N·m (37 lb ft).

  8. Install the adjuster leg covers.
  9. Secure the covers with push pins.
  10. Enable the SIR system. Refer to SIR Disabling and Enabling or to SIR Disabling and Enabling in SIR.

    11. Object Number: 1294372 Size: SH
  11. Remove the protective cover and raise the folding top.