Tools Required

1. Remove the powertrain. Refer to Powertrain Removal and Installation .



2. Remove the driveline support assembly. Refer to Driveline Support Assembly Replacement in Propeller Shaft.
3. Remove the intake manifold. Refer to Intake Manifold Replacement .



4. Install the EN 46326 .
5. Remove the engine flywheel bolts.
6. Remove the flywheel and the reinforcement.
7. Clean and inspect the engine flywheel. Refer to Engine Flywheel Cleaning and Inspection .

1. Apply sealant to the flywheel mounting bolts. Refer to Adhesives, Fluids, Lubricants, and Sealers for the correct part number.



2. Position the flywheel and the reinforcement to the crankshaft.

Notice: Refer to Fastener Notice in the Preface section.

3. Install the flywheel mounting bolts.

3.1.	First Pass

Tighten
Tighten the flywheel mounting bolts to 15 N·m (11 lb ft).

3.2.	Final Pass

Tighten the flywheel mounting bolts an additional 50 degrees using the J 45059 .




4. Remove the EN 46326 .
5. Install the intake manifold. Refer to Intake Manifold Replacement .
6. Install the driveline support assembly. Refer to Driveline Support Assembly Replacement in Propeller Shaft.
7. Install the powertrain. Refer to Powertrain Removal and Installation .