Circuit Description
This test checks the validity of the module FLASH memory calibration values. Error detection is performed inside the control module. No external circuits are involved.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC B1013 Calibration Read Only Memory (ROM) Checksum Error
Conditions for Running the DTC
The module runs the program to detect a FLASH calibration error after each wake-up. The only requirements are battery positive voltage and ground.
Conditions for Setting the DTC
The module retains a copy of the FLASH calibration checksum reference value in the FLASH memory. During wake-up the module shall compute the FLASH calibration value and compare it to the FLASH calibration checksum reference value. If the 2 values do not match the module sets this DTC.
Action Taken When the DTC Sets
The module may have limited functional operation depending on the severity of the FLASH calibration corruption. The module physical operation will allow for the module to be reprogrammed to correct the malfunction.
Conditions for Clearing the DTC
| • | A current DTC clears when the malfunction is no longer present. |
| • | A history DTC clears when the module ignition cycle counter reaches the reset threshold, without a repeat of the malfunction. |
Diagnostic Aids
The following are most likely cause for this DTC being set:
| • | Incorrect files downloaded to the module |
| • | A module installed in the vehicle without the reprogramming procedure having been performed. |
Step | Action | Yes | No |
|---|---|---|---|
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 |
Does the DTC reset? | Go to Step 3 | Go to Diagnostic Aids |
3 | Replace the module setting the DTC as current. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement? | Go to Step 4 | -- |
4 |
Does the DTC reset? | Go to Step 2 | System OK |
