Caution: Do not attempt to repair or alter the head impact energy-absorbing material glued to the headliner or to the garnish trims. If the material is damaged, replace the headliner and/or the garnish trim. Failure to do so could result in personal injury.

1. Manually open the folding top as shown in the illustration. Refer to Folding Top Manual Operation .
2. Remove the trim panel retainer from the folding top headliner. Refer to Folding Top Headlining Trim Panel Retainer Replacement .



3. Remove the retaining screws at the rear of the folding top roof panel.
4. Remove the side trim panel retainer from the folding top headliner. Refer to Folding Top Headlining Trim Panel Side Retainer Replacement .
5. Lower the headliner from the folding top panel.
6. Disconnect the electrical connector to the intrusion sensor, if equipped.
7. Remove the headliner assembly.

1. Install the headliner to the vehicle.
2. Connect the electrical connector to the intrusion sensor.
3. Install the headliner to the folding top panel.
4. Install the side trim panel retainer to the folding top headliner. Refer to Folding Top Headlining Trim Panel Side Retainer Replacement .

Notice: Refer to Fastener Notice in the Preface section.

5. Install the retaining screws at the rear of the folding top roof panel.

Tighten
Tighten the screws to 2.5 N·m (22 lb in).

6. Install the trim panel retainer to the folding top headliner. Refer to Folding Top Headlining Trim Panel Retainer Replacement .
7. Manually close the folding top. Refer to Folding Top Manual Operation .