GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2005 🢒 XLR 🢒 Engine 🢒 Engine Controls - 4.6L (LH2) 🢒 Crankshaft Position Sensor Replacement

Removal Procedure
  1. Remove the intake manifold. Refer to Intake Manifold Replacement .

    2. Object Number: 928205 Size: SH
  2. Disconnect the crankshaft position sensor electrical connector.
  3. Remove the crankshaft sensor retaining bolt.
  4. Remove the crankshaft sensor.

Installation Procedure

    Object Number: 928205 Size: SH

    Important: Inspect the crankshaft sensor O-ring for wear or damage. If a problem is found, replace the O-ring.

  1. Lubricate the crankshaft sensor O-ring with clean engine oil.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the crankshaft sensor and the retaining bolt.

    3. Tighten
    Tighten the retaining bolt between 10 N·m (89 lb in).

  3. Connect the crankshaft position sensor electrical connector.
  4. Install the intake manifold. Refer to Intake Manifold Replacement .
  5. Operate the engine and inspect crankshaft sensor for engine oil leaks.
  6. Perform the Crankshaft Position System Variation Learn .