Tools Required

1. Remove the hood. Refer to Hood Replacement in Body Front End.
2. Disconnect the negative battery cable from the battery. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
3. Remove the negative battery cable from the right rear cylinder head. Refer to Battery Negative Cable Replacement in Engine Electrical.
4. Install the J 28467-86 Right Engine Lift Bracket to the right cylinder head.
5. Remove the bolt securing the wiring harness to the left cylinder head.
6. Install the J 28467-87 Left Engine Lift Bracket to the left cylinder head.



7. Assemble a J 28467-83 Rear Crossbar Supports to each end of the J 28467-3 Rear Crossbar.



8. Position the rear crossbar assembly over the hood hinge brackets with the support located over each hood safety catch bracket.



9. Assemble a J 28467-82 Front Crossbar Legs to each end of the J 28467-85 Front Crossbar.



10. Install the 0.5 in X 2.5 in  J 28467-10 Quick Release Pins.



11. Place the front crossbar assembly with supporting legs on the right and left frame rails. Each leg should rest in the shock absorber upper mount on the frame rail.
12. Install the right and left sidebars over the front and rear crossbars.



13. Install the J 28467-1A assembly and hand tighten.
14. Repeat steps 12 and 13 for the remaining three corners of the support fixture assembly.



15. Install the J 28467-7A lift hook through the J 28467-6A lift hook bracket.
16. Install the ½ inch lift hook washer and the J 28467-34 lift hook wing nut onto the J 28467-7A lift hook.



17. Install the J 28467-6A assembled lift hook (1) over the J 28467-84 left sidebar (2).
18. Adjust the J 28467-6A assembled lift hook bracket (1) in order to align the hook with the J 28467-87 left engine lift hook bracket.



19. Repeat step 18 for the right lift bracket.



20. Install each J 28467-7A lift hook through each engine lift hook bracket. Ensure that the hooks do not damage the surrounding components.
21. Hand-tighten the J 28467-34 lift hook wing nuts securely to remove all slack from the engine support fixture assembly.

1. Remove the J 28467-B .
2. Remove the J 28467-87 left engine lift bracket from the left cylinder head.
3. Install the bolt securing the wiring harness to the left cylinder head.
4. Remove the J 28467-86 right engine lift bracket from the right cylinder head.
5. Install the negative battery cable to the right rear cylinder head. Refer to Battery Negative Cable Replacement in Engine Electrical.
6. Install the hood. Refer to Hood Replacement in Body Front End.