Instrument Panel Insulator Panel Replacement - Right Side LHD

1. Remove the fasteners (1) at the rear edges of the insulators in order to disengage the insulators from the lower instrument panel (IP).
2. Push in on the snap tab retainers in order to release the fasteners.



3. Disconnect the electrical connectors (1,2).
4. Slide the insulator (3) rearward toward the vehicle.

1. Set the forward edge of the insulator shelf on the carpeting at the front of the vehicle.
2. Connect the electrical connectors (1,2).



3. Align the insulator with the floor duct at the HVAC module.
4. Align the snap tab fasteners with the lower IP and push the insulator upward in order to engage the fasteners.

Notice: Refer to Fastener Notice in the Preface section.

5. Install the insulator fasteners (1) into the lower IP.

Tighten
Tighten the fasteners to 2 N·m (18 lb in).

Instrument Panel Insulator Panel Replacement - Right Side RHD

1. Remove the fasteners (1) at the rear edge of the insulator.
2. Push on the left and the right retainers at the rear edge of the insulators in order to disengage the insulators from the lower IP.



3. Disconnect the electrical connectors (1,3).



4. Slide the insulator (2) rearward toward the vehicle in order to clear the park brake bracket.

1. Slide the insulator (2) over the top of the park brake bracket.



2. Connect the electrical connectors (1,3).



3. Set the forward edge of the insulator onto the shelf on the carpeting at the front of the vehicle.
4. Align the insulator with the floor duct at the HVAC module.
5. Align the snap tab fasteners with the lower IP and push the insulator upward in order to engage the fasteners.

Notice: Refer to Fastener Notice in the Preface section.

6. Install the insulator fasteners (1) into the lower IP.

Tighten
Tighten the fasteners to 2 N·m (18 lb in).