GM Service Manual Online
For 1990-2009 cars only

Step

Action

Yes

No

Schematic Reference: Instrument Cluster Schematics

1

Did you perform the Instrument Cluster Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Instrument Cluster

2

  1. Install a scan tool.
  2. Turn the ignition ON, with the engine OFF.
  3. With a scan tool, observe the Engine Oil Level Switch parameter in the PCM Engine 3 data list.

Does the Engine Oil Level Switch parameter display OK?

Go to Step 3

Go to Step 4

3

Is the low engine oil indicator illuminated?

Go to Step 11

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

4

  1. Turn the ignition OFF.
  2. Disconnect the engine oil level switch.
  3. Connect a 3 ampere fused jumper between the oil level switch signal circuit and a good ground.
  4. Turn the ignition ON, with the engine OFF.
  5. With the scan tool, observe the Engine Oil Level Switch parameter.

Does the Engine Oil Level Switch parameter display OK?

Go to Step 6

Go to Step 5

5

Test the oil level switch signal circuit for an open or for a high resistance. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 8

6

Test the ground circuit of the engine oil level switch for an open or for a high resistance. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 7

7

Inspect for poor connections at the harness connector of the engine oil level switch. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 9

8

Inspect for poor connections at the harness connector of the PCM. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 10

9

Replace the engine oil level switch. Refer to Engine Oil Level Sensor Replacement .

Did you complete the replacement?

Go to Step 12

--

10

Important: Program the replacement PCM.

Replace the PCM. Refer to Powertrain Control Module Replacement in Engine Controls.

Did you complete the replacement?

Go to Step 12

--

11

Replace the IPC. Refer to Instrument Cluster Replacement .

Did you complete the replacement?

Go to Step 12

--

12

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2