- Connect the driver side
(seat) air bag and pretensioner yellow connector (2) to the vehicle
harness yellow connector (1).
- Install both Connector Position Assurance (CPA) locks (3)
to the driver side (seat) air bag and pretensioner yellow connector (1)
located under the driver seat.
- Connect the passenger side (seat) air bag and pretensioner yellow
connector (2) to the vehicle harness yellow connector (1).
- Install both Connector Position Assurance (CPA) locks (3)
to the passenger side (seat) air bag and pretensioner yellow connector (1)
located under the passenger seat.
- Connect the passenger
(IP) frontal air bag yellow connector (2) to the vehicle harness yellow
connector (1) located above the passenger sound insulator.
- Install the Connector Position Assurance (CPA) (4) to the
passenger yellow connector (1).
- Install the passenger sound insulator. Refer to
Instrument Panel Insulator Panel Replacement - Right Side
in Instrument Panel,
Gages and Console.
- Connect the driver frontal
air bag yellow connector (4) to the vehicle harness yellow connector (3)
located next to steering column (2).
- Install the Connector Position Assurance (CPA) (1) to the
driver yellow connector (3).
- Install the driver sound insulator. Refer to
Instrument Panel Insulator Panel Replacement - Left Side
in Instrument Panel,
Gages and Console.
- Install the SIR fuse to
the rear fuse block.
- Install the rear seat. Refer to
Rear Seat Cushion Replacement
in Seats.
- Staying well away from all air bags, turn the ignition switch
to the ON position.
| 13.1. | The AIR BAG warning lamp will flash 7 times. |
| 13.2. | The AIR BAG warning lamp will then turn OFF. |
- Perform the SIR Diagnostic System Check if the AIR BAG warning
lamp does not operate as described. Refer to
Diagnostic System Check - SIR
.
