Special Tools

For equivalent regional tools, refer to Special Tools.

1. Remove the transfer case. Refer to Transfer Case Assembly Replacement.
2. Using the J 45278 seal remover  (2) and the J-2619-A slide hammer  (1), slide the hook end of the J 45278 seal remover beside the seal lip and shaft. Turn the hook approximately 60 degrees and pull the seal out with the J-2619-A slide hammer  (1).



3. Clean the seal area (1) and input shaft of any old seal material with solvent.



4. Use the J 8092 driver handle  (1) and the J 46269 seal installer  (2) to drive in a NEW input seal.
5. Install the transfer case. Refer to Transfer Case Assembly Replacement.