The engine oil temperature sensor is a thermistor that varies in resistance as the engine oil temperature changes. A low engine oil temperature produces a high resistance at the engine oil temperature sensor. A high engine oil temperature produces a low resistance at the engine oil temperature sensor. The engine control module (ECM) with the engine oil temperature sensor via a discreet signal circuit and low reference circuit. The ECM applies 5 volts to the engine oil temperature sensor and calculates temperature based on the engine oil temperature sensor voltage. The engine oil temperature range is between -40 to +165°C (-40 to +329°F).

Schematic Reference

Instrument Cluster Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Instrument Cluster Description and Operation

Electrical Information Reference

Scan Tool Reference

Control Module References for scan tool information

1. Ignition OFF, disconnect the harness connector at the engine oil temperature sensor.
2. Ignition OFF, test for less than 1 ohm between the low reference circuit terminal C and ground.

⇒	If greater than the specified range, test the low reference circuit for an open/high resistance.

3. Ignition ON, verify the scan tool Engine Oil Temperature Calculated parameter is less than -10°C (+14°F)

⇒	If greater than the specified range, test the signal circuit terminal B for a short to ground. If the circuit tests normal, replace the ECM.

4. Ignition ON, install a 3A fused jumper wire between the signal circuit terminal B and the low reference circuit terminal C. Verify the scan tool Engine Oil Temperature Calculated parameter is greater the 150°C (302°F).

⇒	If less than the specified range, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.

5. If all circuits test normal, test or replace the engine oil temperature sensor.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.