For 1990-2009 cars only
- Loosen the jam nut (1) on the outer tie rod.
- Rotate the inner tie rod to the required toe specification setting. Refer to Wheel Alignment Specifications.
- Tighten the jam nut to the outer tie rod.
- Check the toe setting after tightening. Refer to Wheel Alignment Specifications.
- Re-adjust the toe setting if necessary.
Notice: Care must be taken that the boots are not twisted when rotating the inner tie rods, or damage to the boots may result.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the nut to 55 N·m (41 lb ft).
