GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the driver side instrument panel (I/P) insulator closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gages, and Console.

  2. Object Number: 1233592  Size: SH
  3. Remove the bolt (1) securing the brake pedal position switch to the brake panel bracket.
  4. Remove the switch.

Installation Procedure


    Object Number: 1233592  Size: SH
  1. Connect the electrical connector on the switch.
  2. Align the brake panel position switch to the stud (3).
  3. Notice: Refer to Fastener Notice in the Preface section.

  4. Install the bolt (1) securing the brake panel position switch to the brake panel bracket.
  5. Tighten
    Tighten the bolt (1) to 9 N·m (80 lb in).

  6. Install the driver side I/P insulator closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gages, and Console.
  7. Recalibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration .