Schematic Reference: Door Lock/Indicator Schematics

Connector End View Reference: Computer/Integrating Systems Connector End Views in Computer/Integrating Systems

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

1. Install a scan tool.
2. Turn the ignition ON, with the engine OFF.
3. Read current personalization setting for the automatic door locks. Refer to Driver Personalization in Personalization for a description of door lock mode functions.
4. Close all doors.
5. Shift the gear selector out of PARK.
6. Shift the gear selector into PARK.
7. Turn OFF the ignition.

Did the power door locks operate as expected for the mode selected?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

With the scan tool, observe the Door Open Switch of each door in each door control module data list.

Does the scan tool indicate that the Door Open Switch parameter is in the Closed state for all doors?

Go to Step 4

Go to Courtesy Lamps Always On in Lighting Systems

Inspect for poor connections at the harness connector of the rear integration module (RIM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 6

Go to Step 5

Important:: The Automatic Door Locks personalization mode must be reset following RIM replacement. Refer to Driver Personalization in Personalization.

Replace the RIM. Refer to Control Module References in Computer/Integrating Systems.

Did you complete the replacement?

Go to Step 6

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2