GM Service Manual Online
For 1990-2009 cars only

Object Number: 1616170  Size: MF

Callout

Component Name

Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedures

  1. Remove the engine sight shield. Refer to Intake Manifold Sight Shield Replacement .
  2. Remove the front section of the supercharger inlet duct. Refer to Supercharger Inlet Duct Assembly Replacement .
  3. Remove the supercharger drive belt. Refer to Supercharger Belt Replacement .
  4. Remove the air conditioning, power steering, and water pump drive belt. Refer to Water Pump and Air Conditioning Compressor and Power Steering Pump Belt Replacement .
  5. Remove the charge air cooler coolant pump. Refer to Charge Air Cooler Coolant Pump Replacement .
  6. Remove the generator drive belt. Refer to Generator Drive Belt Replacement .

1

Drive Belt Tensioner Assembly Bolt

Tighten
50 N·m (37 lb ft)

2

Drive Belt Tensioner Assembly

Tip

    • Rotate the tensioner in a clockwise direction during belt removal and installation.
    • Remove and install the bolt and tensioner as an assembly.
    • Ensure that the alignment pin on the rear of the tensioner assembly is aligned with the locating hole on the engine during the installation and torque procedure.