GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2009 🢒 SRX 🢒 Preface 🢒 Dangers, Warnings, and Cautions 🢒 Heated Oxygen Sensor Replacement - Bank 1 Sensor 1

Removal Procedure

Caution: Refer to Oxygen Sensor Caution in the Preface section.

Note: 

   • Bank 1 on the LH2 engine in this vehicle is the right side of the engine while sitting in the driver seat.
   • Sensor 1 is the sensor closest to the engine, or farthest forward toward the front of vehicle.
   • A special anti-seize compound is used on the oxygen sensor threads. New service sensors should already have the compound applied to the threads. Coat the threads of a reused sensor with anti-seize compound P/N 5613695 or equivalent.


    Object Number: 887916 Size: SH
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement.
  2. Disconnect the oxygen sensor electrical connector from the engine wiring harness connector at the rear of the right head.
  3. Note the wire routing and attachment points for reassembly.
  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.

    5. Object Number: 887903 Size: SH
  5. Remove oxygen sensor from the exhaust manifold.

Installation Procedure

    Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 887903 Size: SH
  1. Install the heated oxygen sensor (HO2S) in the exhaust manifold and tighten to 42 N·m (31 lb ft).
  2. Lower the vehicle.

    3. Object Number: 887916 Size: SH
  3. Route and attach the wiring as noted in disassembly.
  4. Connect the oxygen sensor electrical connector to the engine wiring harness connector at the rear of the right head.
  5. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement.