GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2009 🢒 SLS 🢒 Power and Signal Distribution 🢒 Wiring Systems and Power Management 🢒 Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left Side) Intake

Removal Procedure
  1. Turn the ignition OFF.

    2. Note: Do not disconnect the power steering fluid lines/hoses from the reservoir.

  2. Remove the power steering fluid reservoir bolts and reposition the power steering fluid reservoir in order to provide access. Refer to Power Steering Fluid Reservoir Replacement.

    3. Object Number: 1285232 Size: SH
  3. Remove the camshaft position (CMP) actuator valve electrical connector.

    4. Object Number: 1285234 Size: SH
  4. Remove the camshaft position actuator valve bolts.
  5. Remove the CMP actuator valve.
  6. Inspect the CMP actuator valve seal for damage and replace as necessary.

Installation Procedure
  1. Inspect the CMP actuator valve seal for damage. Replace components if necessary.

    2. Object Number: 1285234 Size: SH
  2. Install the CMP actuator valve.

    3. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the CMP actuator valve bolt and tighten to 10 N·m (89 lb in).

    4. Object Number: 1285232 Size: SH
  4. Install the CMP actuator valve electrical connector.
  5. Install the power steering fluid reservoir. Refer to Power Steering Fluid Reservoir Replacement.