GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the generator and water pump drive belt. Refer to Water Pump and Generator Belt Replacement.

  2. Object Number: 887773  Size: SH
  3. Loosen the drive belt tensioner bolt.
  4. Remove the drive belt tensioner and bolt from the engine.

Installation Procedure


    Object Number: 887773  Size: SH
  1. Position the drive belt tensioner and bolt to the engine as an assembly.
  2. Ensure that the alignment pin on the rear of the tensioner assembly is aligned with the locating hole on the engine.
  3. Caution: Refer to Fastener Caution in the Preface section.

  4. Install the drive belt tensioner bolt.
  5. Tighten
    Tighten the drive belt tensioner bolt to 50 N·m (37 lb ft).

  6. Install the generator and water pump drive belt. Refer to Water Pump and Generator Belt Replacement.