GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 796810  Size: SH
  1. Unlock the transmission control module (TCM) electrical connector by pulling the retainer (2) away from the electrical connector (1).
  2. Important: Twisting or tilting of the TCM electrical connector while disconnecting may result in bent or misaligned electrical terminal pins.

  3. Carefully disconnect the electrical connector (1) from the transmission control module.

  4. Object Number: 796811  Size: SH
  5. Remove the transmission control module from the mounting bracket by pulling back on the retaining tabs (1) to release the control module.

Installation Procedure


    Object Number: 796811  Size: SH
  1. Align the transmission control module with the locating pins (2) on the module mounting bracket.
  2. Install the transmission control module by seating it fully into the bracket until all of the retaining tabs (1) have engaged the edge of the module edge.

  3. Object Number: 796810  Size: SH

    Important: Twisting or tilting of the transmission control module electrical connector while connecting may result in bent or misaligned electrical terminal pins.

  4. Carefully connect the transmission control module electrical connector (1) to the transmission control module.
  5. Lock the transmission control module electrical connector securely to the transmission control module by pushing the retainer (2) toward the electrical connector (1) until fully seated.
  6. The transmission control module must be programmed with the proper software/calibrations. Refer to Control Module References .
  7. Important: It is recommended that transmission adaptive pressure (TAP) information be reset.

    Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, the engine control module (ECM), powertrain control module (PCM) or TCM will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.

  8. Reset the TAP values. Refer to Transmission Adaptive Functions .
  9. Refer to Control Module References for programming and setup information.