Special Tools

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
3. Remove the rear brake rotor. Refer to Rear Brake Rotor Replacement .
4. Remove the wheel driveshaft nut and discard.



5. Disconnect the antilock brake system (ABS) sensor harness connector.
6. Disconnect the ABS sensor harness connector from the backing plate.



7. Remove the parking brake cable bracket from the knuckle. Refer to Park Brake Cable Mounting Bracket Replacement .
8. Remove the parking brake cable from the parking brake lever (3).



9. Remove the upper ball joint mounting nut.



10. Using J 43631 separate the ball stud from the knuckle.



11. Support the lower control arm with a suitable jack.



12. Remove the lower dampener mounting bolt.



13. Remove the trailing arm to knuckle mounting bolt and nut.



14. Remove the lower control arm to knuckle mounting bolt.



15. Remove the adjustment link to knuckle mounting bolt.



16. Install J 45859 or equivalent to the wheel bearing/hub.

Important: May need to use the wheel hub remover to fully disengage the wheel bearing/hub from the drive axle.

17. Using the J 45859 or equivalent, disengage the wheel drive shaft from the wheel bearing/hub.



18. Remove the knuckle from the vehicle.
19. Remove the wheel bearing/hub bolts.
20. Remove the knuckle and backing plate from the wheel bearing/hub.

1. Install the knuckle and backing plate to the wheel bearing/hub.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the wheel bearing/hub mounting bolts.

Tighten
Tighten the bolts to 116 N·m (85 lb ft).




3. Install the knuckle to the vehicle.

Important: Loosely install all fasteners before tightening.

4. Install the adjustment link to knuckle mounting bolt.

Tighten
Tighten the adjustment link to knuckle bolt to 161 N·m (118 lb ft).




5. Install the trailing arm to knuckle mounting bolt and nut.

Tighten
Tighten the trailing arm to knuckle bolt to 172 N·m (127 lb ft).




6. Install the lower dampener and mounting bolt.

Tighten
Tighten the lower shock mounting bolt to 150 N·m (111 lb ft).




7. Install the lower control arm to knuckle mounting bolt.

Tighten
Tighten the lower control arm to knuckle retaining bolt to 161 N·m (118 lb ft).




8. Connect the upper ball joint to the knuckle.
9. Install the upper ball joint mounting nut.

Tighten
Tighten the nut to 66 N·m (48 lb ft).

10. Install the parking brake cable bracket to the knuckle. Refer to Park Brake Cable Mounting Bracket Replacement .
11. Remove the jack.



12. Connect the ABS sensor electrical connector to the backing plate.
13. Connect the ABS sensor electrical connector.



14. Install a new wheel drive shaft nut.

Tighten
Tighten the nut to 160 N·m (118 lb ft).

15. Install the brake rotor. Refer to Rear Brake Rotor Replacement .
16. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
17. Lower the vehicle.