GM Service Manual Online
For 1990-2009 cars only

Diagnostic Instructions

    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    •  Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptors

DTC P0562:  System Voltage High

DTC P0563:  System Voltage Low

Circuit/System Description

The transmission control module (TCM) continuously monitors the system voltage on the Ignition 1 voltage circuits. Lower than normal voltage may be inadequate to operate the transmission control solenoids properly. Improper solenoid operation may cause erratic transmission operation, which may result in internal damage.

Conditions for Running the DTC

P0562

    • Ignition voltage has been greater than 12 volts for 1 second this ignition cycle.
    • Engine speed is 1200 RPM or greater.

P0563

Ignition voltage has been greater than 12 volts for 1 second this ignition cycle.

Conditions for Setting the DTC

P0562

The TCM detects system voltage is 11 volts or less for 10 seconds.

P0563

The TCM detects system voltage is 18 volts or greater for 10 seconds.

Action Taken When the DTC Sets

DTCs P0562 and P0563 are Type C DTCs.

Conditions for Clearing the DTC

DTCs P0562 and P0563 are Type C DTCs.

Diagnostic Aids

    • Observe the driver information center (DIC) messaging that would indicate the electrical system requires service.
    • Inspect for the following conditions:
       - Loose or damaged terminals at the generator
       - Loose or worn generator drive belt

Reference Information

Schematic Reference

Automatic Transmission Controls Schematics

Connector End View Reference

    •  Automatic Transmission Inline 16-Way Connector End View
    •  Automatic Transmission Internal Connector End Views
    •  Automatic Transmission Related Connector End Views

Scan Tool Reference

    •  Scan Tool Output Controls
    •  Scan Tool Data List
    •  Scan Tool Data Definitions

DTC Type Reference

    •  Diagnostic Trouble Code (DTC) Type Definitions
    •  Diagnostic Trouble Code (DTC) List/Type

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Testing for Intermittent Conditions and Poor Connections
    •  Wiring Repairs

Circuit/System Verification

Engine ON, measure and record the battery voltage with a DMM. The battery voltage should be between 12.5-14.5 volts.

If the voltage is not within the specified value, or the charge indicator light is ON, go to Charging System Test .

Circuit/System Testing

Engine ON, the scan tool Ignition voltage parameter should display between 12.5-14.5 volts.

If the voltage is not within the specified value, test the ignition voltage circuit for an open circuit or short to ground.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Perform the Service Fast Learn Adapts .