For 1990-2009 cars only
Removal Procedure
- Relieve the fuel system pressure. Refer to Fuel Pressure Relief .
- Blow dirt out of the fitting using compressed air.
- Squeeze the plastic tabs of the male end connector.
- Pull the connection apart.
- Using a clean shop towel, wipe off the male pipe end.
- Inspect both ends of the fitting for dirt and burrs.
- Clean or replace the components if necessary.
Caution: Refer to Gasoline/Gasoline Vapors Caution in the Preface section.
Installation Procedure
- Apply a few drops of clean engine oil to the male pipe end.
- Push both sides of the quick-connect fitting together to cause the retaining tabs/fingers to snap into place.
- Pull on both sides of the quick-connect fitting to make sure the connection is secure.
- Inspect for leaks using the following procedure:
Caution: In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean engine oil to the male pipe ends.
This will ensure proper reconnection and prevent a possible fuel leak. During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.
| 4.1. | Turn the ignition to ON without the engine running for 2 seconds. |
| 4.2. | Turn the ignition OFF for 10 seconds. |
| 4.3. | Turn the ignition to ON without the engine running for 2 seconds. |
| 4.4. | Turn the ignition OFF. |
| 4.5. | Inspect for leaks. |
