Schematic Reference: Wiper/Washer Schematics

Connector End View Reference: Wiper/Washer Connector End Views

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

Verify that the moisture sensing inoperative fault is present.

Does the system operate normally?

Go to Testing for Intermittent Conditions and Poor Connections

Go to Step 3

While the windshield wiper/washer system is in the automatic mode does the wiper motor operate at normal delay intervals?

Go to Step 5

Go to Step 4

1. Turn the ignition ON.
2. Operate the windshield wiper/washer switch from the OFF position through all of the delay positions.

Does the wiper motor cycle once and stop every time the switch is advanced to the next delay position?

Go to Step 5

Go to Windshield Wiper Washer System Malfunction

1. Disconnect the outside moisture sensor connector.
2. Connect a test lamp from the accessory voltage circuit of the moisture sensor connector to a good ground.

Does the test lamp illuminate?

Go to Step 6

Go to Step 10

Connect a test lamp between the accessory voltage circuit of the moisture sensor connector and the ground circuit of the moisture sensor connector.

Does the test lamp illuminate?

Go to Step 7

Go to Step 11

Test the outside moisture sensor signal 1 circuit for the following conditions:

Refer to Circuit Testing and Wiring Repairs .

Did you find and correct the condition?

Go to Step 13

Go to Step 8

Test the outside moisture sensor signal 2 circuit for the following conditions:

Refer to Circuit Testing and Wiring Repairs .

Did you find and correct the condition?

Go to Step 13

Go to Step 9

Inspect for poor connections at the harness connector of the outside moisture sensor. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 13

Go to Step 12

Repair the short to ground or open in the accessory voltage circuit of the outside moisture sensor. Refer to Circuit Testing and Wiring Repairs .

Is the repair complete?

Go to Step 13

--

Repair the high resistance or open in the ground circuit of the outside moisture sensor. Refer to Circuit Testing and Wiring Repairs .

Is the repair complete?

Go to Step 13

--

Replace the outside moisture sensor Refer to Windshield Outside Moisture Sensor Replacement .

Did you complete the replacement?

Go to Step 13

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2