GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2005 🢒 Escalade - 2WD 🢒 Suspension 🢒 Suspension General Diagnosis 🢒 Leaf Spring Replacement

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Support the rear axle independently in order to relieve the tension on the leaf springs.
  3. Disconnect the electronic suspension control (ESC) sensors, if equipped. Refer to Electronic Suspension Rear Position Sensor Replacement - Left Side or Electronic Suspension Rear Position Sensor Replacement - Right Side in Electronic Suspension Control (ESC).
  4. Remove the trailer hitch, if equipped. Refer to Trailer Hitch Replacement in Frame and Underbody.
  5. Remove the fuel tank for left side applications. Refer to Fuel Tank Replacement in Engine Controls - 4.8L, 5.3L, 6.0L.

    6. Object Number: 348393 Size: SH
  6. Remove the U-bolt nuts.
  7. Remove the U-bolts.
  8. Remove the spring spacer.
  9. Remove the anchor plate.

    10. Object Number: 361791 Size: SH
  10. Remove the rear spring bracket nut and bolt.

    11. Object Number: 361767 Size: SH
  11. Remove the front spring bracket nut and bolt.
  12. Remove the leaf spring assembly from the vehicle.

Installation Procedure

    Object Number: 361767 Size: SH
  1. Install the leaf spring assembly to the vehicle.
  2. Loosely assemble the spring to the front hanger bracket.
  3. Install the front spring hanger bracket bolt.
  4. Install the front spring hanger bracket nut.

    5. Object Number: 361791 Size: SH
  5. Install the rear spring hanger bracket bolt.
  6. Install the rear spring hanger bracket nut.

    7. Important: Do not reuse the U-bolts.


    Object Number: 348393 Size: SH
  7. Install the spring spacer.
  8. Install the U-bolts.
  9. Install the anchor plate.

    10. Notice: Refer to Fastener Notice in the Preface section.

  10. Install the U-bolt nuts.

    11. Tighten

        • Tighten the front hanger bracket nut to 150 N·m (110 lb ft).
        • Tighten the rear hanger bracket nut to 95 N·m (70 lb ft).
  11. Install the fuel tank for left side applications. Refer to Fuel Tank Replacement in Engine Controls- 4.8L, 5.3L, 6.0L.
  12. Install the trailer hitch, if equipped. Refer to Trailer Hitch Replacement in Frame and Underbody.
  13. Connect the electronic suspension control (ESC) sensors, if equipped. Refer to Electronic Suspension Rear Position Sensor Replacement - Left Side or Electronic Suspension Rear Position Sensor Replacement - Right Side in Electronic Suspension Control (ESC).
  14. Remove the rear axle support.
  15. Remove the safety stands.
  16. Lower the vehicle.