GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 741425  Size: SH

    Important: When any molding is removed, all retaining clips needs to be replaced with new ones if the molding is to be reused.

  1. Remove all retaining screws.
  2. Grasp the lower part of the molding.
  3. Pull outwards to release the clips from the body panel.

Installation Procedure


    Object Number: 741425  Size: SH
  1. Use a 3M™ scotch brite molding adhesive remover disk P/N 07501 or equivalent to remove any adhesive tape on the body panel.
  2. Peel off the adhesive tape protective lining.
  3. Align the retaining clips in their respective holes.
  4. Press firmly on the molding until all the retaining clips are fully seated.
  5. Press on the top part of the molding so that the tape adheres to the body panel.