GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2006 🢒 Escalade EXT 🢒 Driveline/Axle 🢒 Transfer Case - NVG 246-NP8 🢒 Transfer Case Shift Control Switch Replacement

Removal Procedure

    Object Number: 830158 Size: SH
  1. Remove the instrument panel (I/P) cluster bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement in Instrument Panel, Gages, and Console.
  2. Using a flat-tipped screwdriver, gently pry the retaining clips open on the housing.
  3. Slide out the selector switch until the electrical connectors are accessible.
  4. Disconnect the selector switch electrical connectors (2, 3).

    5. Object Number: 396838 Size: SH
  5. Remove the selector switch from the housing.

Installation Procedure

    Object Number: 396838 Size: SH
  1. Position the selector switch close to the housing so the electrical connectors can be connected.

    2. Object Number: 830158 Size: SH
  2. Connect the selector switch electrical connectors (2, 3).
  3. Slide the selector switch into the housing until the switch snaps into place.

    4. Important: Make sure that the selector switch is seated properly in the housing before installing the IP cluster bezel.

  4. Install the I/P cluster bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement in Instrument Panel, Gages, and Console.