GM Service Manual Online
For 1990-2009 cars only

Power Steering Gear Outlet Pipe/Hose Replacement Recirculating Ball

Removal Procedure


    Object Number: 650864  Size: SH

    Notice: Do not start the vehicle with any power steering gear inlet or outlet hoses disconnected. When disconnected, plug or cap all openings of components. Failure to do so could result in contamination or loss of power steering fluid and damage to the system.

  1. Install a drain pan under the vehicle.
  2. Remove the power steering gear outlet hose (3) from the steering gear (2).
  3. Remove the clamp retaining the power steering gear outlet hose (3) to the power steering pump (1).
  4. Remove the power steering gear outlet hose from the power steering pump.

  5. Remove the power steering gear outlet hose from the vehicle.

Installation Procedure


    Object Number: 650864  Size: SH

    Notice: The inlet and outlet hoses must not be twisted during installation. Do not bend or distort the inlet or outlet hoses to make installation easier. Failure to follow these procedures could result in component damage.

  1. Route the hose in the same position the hose occupied prior to removal.
  2. Install the power steering gear outlet hose (3) to the power steering pump (1).
  3. Position the clamp at the end of the hose.

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the power steering gear outlet hose to the power steering gear.
  5. Tighten
    Tighten the outlet hose fitting to 28 N·m (20 lb ft).

  6. Remove the drain pan from under the vehicle.
  7. Bleed the power steering system. Refer to Power Steering System Bleeding .