Rear Axle Shaft Seal and/or Bearing Replacement 8.6 Inch Axle W/O JL4, 9.5 Inch Axle

Tools Required

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
3. Remove the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement .
4. Remove the axle shaft. Refer to Rear Axle Shaft Replacement .



5. Remove the axle shaft seal and the bearing from the axle housing using the J 44685 (8.6 inch axle) (1) and the J 2619-01  (2).



6. Remove the axle shaft seal and the bearing from the axle housing using the J 29712 (9.5 inch axle).

1. Install the axle shaft bearing using the J 23690 (8.6 inch axle) (1) or the J 29709 (9.5 inch axle) (1) and the J 8092  (2).
2. Drive the axle shaft bearing into the axle housing until the tool bottoms against the tube.



3. Install the axle shaft seal using the J 21128 (8.6 inch axle) or the J 29713 (9.5 inch axle).
4. Drive the tool into the bore until the axle shaft seal bottoms flush with the tube.
5. Install the axle shaft. Refer to Rear Axle Shaft Replacement .
6. Install the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement .
7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
8. Fill the rear axle. Refer to Rear Axle Lubricant Replacement .
9. Lower the vehicle.

Rear Axle Shaft Seal and/or Bearing Replacement 8.6 Inch Axle W/JL4

Tools Required

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
3. Remove the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement .
4. Remove the axle shaft. Refer to Rear Axle Shaft Replacement .
5. To remove the seal only, use a suitable seal remover.



6. To remove the axle shaft seal and the bearing together from the axle housing, use the J 45857  (1) and the J 2619-01  (2).

1. Install the axle shaft bearing using the J 23690  (1) and the J 8092  (2).
2. Drive the axle shaft bearing into the axle housing until the tool bottoms against the tube.



3. Install the axle shaft seal using the J 21128 .
4. Drive the tool into the bore until the axle shaft seal bottoms flush with the tube.
5. Install the axle shaft. Refer to Rear Axle Shaft Replacement .
6. Install the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement .
7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
8. Fill the rear axle. Refer to Rear Axle Lubricant Replacement .
9. Lower the vehicle.