Callout
| Component Name
|
Preliminary Procedure
- Remove the right lock pillar garnish molding. Refer to
Body Lock Pillar Garnish Molding Replacement.
- Remove the screw from the HVAC duct and reposition the duct away from the module to allow access.
- Remove the right rear quarter trim panel. Refer to
Rear Quarter Trim Panel Replacement - Right Side.
|
1
| Radio Antenna Module Bolt
Caution: Refer to Fastener Caution in the Preface section.
Tighten
9 N·m (80 lb in) |
2
| Radio Antenna Ground Strap Screw
Tighten
2 N·m (18 lb in) |
3
| Radio Antenna Module
Tip
| • | Slide the module up to release module retainers from the key slot. |
| • | Disconnect the electrical connectors. |
| • | Disconnect the antenna leads to the window. |
| • | Use a small flat-bladed screw driver or pick tool to release the plastic retaining tab tongue on cable. The retaining clip is not removable after glass installation, caution must be used to ensure it is not broken. |
|
