GM Service Manual Online
For 1990-2009 cars only

Diagnostic Instructions

    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    •  Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC C0561 71: System Disabled Information Stored Invalid Serial Data Received

Diagnostic Fault Information

Circuit

Short to Ground

Open/High Resistance

Short to Voltage

Signal Performance

System Disabled Information Stored Invalid Serial Data Received

--

--

--

C0561 71

Circuit/System Description

The electronic brake control module (EBCM) receives messages from other modules over GMLAN which are needed to perform antilock brake system (ABS), vehicle stability enhancement system (VSES), or traction control system (TCS) functions.

Conditions for Running the DTC

    • The ignition switch is in the ON position.
    • Ignition voltage is greater than 9.5 volts.

Conditions for Setting the DTC

The power-train control module (PCM) or body control module (BCM) diagnosis a condition prevention the engine control portion of the traction control function and sends a GMLAN message to the EBCM indicating that torque reduction is not allowed. The PCM or BCM will typically set a DTC and the EBCM will set this DTC.

Action Taken When the DTC Sets

One or more of the following actions may occur:

    • The EBCM disables the traction control system (TCS) until the DTC becomes a history DTC.
    • The traction Off Indicator turns ON.
    • The Antilock Brake System (ABS) remains functional.

Conditions for Clearing the DTC

    • The condition for the DTC is no longer present.
    • The EBCM automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.

Reference Information

Schematic Reference

Antilock Brake System Schematics

Connector End View Reference

Antilock Brake System Connector End Views

Description and Operation

ABS Description and Operation

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Testing for Intermittent Conditions and Poor Connections
    •  Wiring Repairs

Scan Tool Reference

Scan Tool Data List for EBCM

Circuit/System Verification

  1. Perform Diagnostic System Check - Vehicle.
  2. Diagnose any other Vehicle DTCs before attempting diagnosis of C0561.
  3. With Tech 2, view Invalid Signal, Data Display list under EBCM.
  4. Important: Not all EBCMs support a Invalid Signal Data Display. If this function is not listed under Tech 2 Data Display then proceed to step 4.

  5. Refer to appropriate module for diagnosing any invalid signal.
  6. If no invalid signal are present, view Signal Fault data in Enhanced DTC Data.
  7. Refer to appropriate module for diagnosing that invalid message data.
  8. Do not replace the EBCM due to this DTC fault.

Repair Verification

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.